Franklin Fueling Systems Tank Sentinel (TS-1001, 2001, 504, & 508) Setup Programming Guide - Manual (Page 128)

21 Page 21 - 8 Tank Sentinel Setup Programming Guide
FAX MODE Menu
Use the optional internal fax/modem to send
reports to remote Fax machines.
Go back / display this menu (at left) and
press
M3 and M2 to access these menus.
FAX MODE Automatically FAX up to 4 numbers when
AUTODIAL Deliveries, Alarms, Reports, Line Tests
FAX AUTODIAL or Leak Test occur
NUMBER 1
NUMBER 2
NUMBER 3
NUMBER 4
(N = number 1, 2, 3, or 4)
FAX NUMBERS N
ACCESS CD (Use the Access Code field when
ACCESS CODE N phone number is longer than 12
characters - see example)
blank 12 characters
Use keypad to input access code.
Press
ENTER to accept this data.
PHONE NUM (Input a FAX phone number)
PHONE NUMBER N
blank
12 characters
(if more than 12 characters - see example)
Use keypad to input FAX number.
Press
ENTER to accept this data.
(Fax/Modem retries several times when busy)
—
CONTINUED ON THE NEXT PAGE
—
COMM PORTS
COMM 1
COMM 2 F A X / M O D E M
*
M1 M2 M3 M4
FAX/MODEM*
DATA MD F A X M O D E
*
M1 M2 M3 M4
ACCESS CODE or PHONE No. AT Command Characters:
D = ( , ) comma = Dial Delay
Example — 88 DD 88 DD 9 1 2072830156 (20 character phone number)
‘Switching code’= 88 Dial Delays= DD
“to dial out”= 9 “long distance”= 1
Access Code: 88 DD 88 DD 9 1 (10) Phone Number: 2072830156 (10)
Cycle console power on and off after
programming is done, or after any COM
PORTS setting is changed. Also, when the
data / fax modem is present, press
CHECK & M3 DIALTONE to see if a dial
tone is detected.
NOTE
☞