Monitoring the decoder video bandwidth, Monitoring the decoder video, Bandwidth – Extron Electronics VN-Matrix 250 User Guide User Manual
Page 80
4.
If required, use the
Framelock Ref
drop‑down list (see figure 58,
3
) to set up
membership of a decoder genlock group (see
5.
Select a video source from the
Source
drop‑down list (see figure 58,
4
).
6.
If required, select the
audio
and
data
check boxes (see figure 58,
5
).
7.
Click the
Save All
tab.
Monitoring the Decoder Video Bandwidth
1
1
2
2
Figure 59.
Decoder Bandwidth (video) Link
1.
In the
Display
tab, select a video source from the drop‑down list (see figure 59,
1
).
2.
Click the
video
link (see figure 59,
2
). The
Bandwidth
(video) tab opens (see
figure 60):
1
1
Figure 60.
Bandwidth (video) Tab
3.
Set the
Channel
Delay
and
Frame
Delay
(see figure 60,
1
). For more information
about the Bandwidth (video) tab, see
on page 61.
4.
Save the changes by clicking
Save All
.
NOTE: The active status information on the video Bandwidth page only updates if
a video source is selected in step 1 above.
VNM 250 • Configuration with the VNM 250 GUI
74