Osd sub-menu, Network sub-menu, Osd sub‑menu network sub‑menu – Extron Electronics VN-Matrix 250 User Guide User Manual
Page 100
OSD Sub-menu
The
OSD sub‑menu allows you to determine what information is overlaid on the
loop‑through display.
OSD
MENU
NEXT
OSD
[Disable]
NEXT
Disable
Device Name
Input Resolution
Both
Figure 77.
VNE 250 Encoder OSD Sub-menu
1.
In the main OSD screen, press
Next to open the OSD sub‑menu.
2.
Use either rotary encoder to select from:
z
Disable the on‑screen display.
z
Device name (if the device name has not been set previously by the user, the
Device ID is displayed).
z
Input resolution and frame rate of the connected source.
z
Both the Device Name and the Input Resolution with the frame rate.
3.
Press
Next
to save the selected values and return to the main
OSD
screen.
4.
Press
Menu
to open the main
Network
screen.
Network Sub-menu
The
Network sub‑menu allows you to review and configure network settings for the
streaming and control ports and for the system controller. The three upper level screens,
which allow you to review the
LAN1-Control settings, LAN2-Stream settings, and
Sys Ctrl settings are read‑only screens.
1.
In the main
Network
screen, press
Next to open the LAN 1-Control screen.
2.
Use the left rotary encoder to select the IP address (
IP) or subnet mask (SM) for the
control network. The appropriate value is displayed on the LCD screen.
3.
Press
Next for less than 3 seconds to open the LAN 2‑Stream screen.
4.
Use the left rotary encoder to select IP address (
IP), subnet mask (SM), gateway (GW),
maximum transmission unit (
MTU), or Mode (MODE) for the streaming network. The
appropriate value is displayed on the LCD screen.
5.
Press
Next for less than 3 seconds to open the Sys Ctrl
screen.
6.
Use the left rotary encoder to select IP address (
IP) or port number (Port) for the system
controller. The appropriate value is displayed on the LCD screen.
7.
Press
Next for less than 3 seconds to return to the main Network screen.
NOTE: These screens are read only. They allow you to select and view a parameter but
not to change it.
VNM 250 • Front Panel Menu Configuration
94