Extron Electronics VN-Matrix 250 User Guide User Manual
Page 134
Command
ASCII Command
(host to unit)
Response
(unit to host)
Additional Description
General
Query Firmware
version
Q
x.xx.xxx
]
Firmware version as
x.xx.xxx
(major.minor.build)
Query Part
Number
N
Pno xx-xxxx-xx
]
Part number
60-1274-01
(encoder)
60-1275-01
(decoder)
Query Model
Name
I
VNE
•
250
•
Matrix
]
or
VNE
•
250
•
Matrix
]
Model name
VNE
•
250
•
Matrix
(encoder)
VND
•
250
•
Matrix
(decoder)
Absolute System
Reset
E
ZQQQ
}
Zpq
]
feature (see
page 99) of the VNM 250
Reboot System
E
1BOOT
}
Boot1
]
Saves and commits any
changes made to the network
settings
Restart Network
E
2BOOT
}
Boot2
]
Works in the same way
as Boot 1. Currently, the
VNM 250 does not support a
restart of network ports alone.
NOTES:
•
Trying to set an IP address, subnet mask, or gateway address while DHCP is enabled, will result in an E14
(Invalid command for this configuration) error message.
•
Using the CISG command (to set the IP address, subnet mask, and gateway address at the same time)
while DHCP is enabled, disables DHCP.
•
Any changes to the network settings require a reboot to enforce them.
•
Currently, SIS implementation by the VNM 250 supports only Extron Verbose mode 0.
•
To comply with industry standards, there cannot be any "1" bits to the right of a "0" bit in a subnet mask.
For example, 255.255.128.0 (11111111.11111111.
10000000.00000000) is valid;
255.255.64.0 (11111111.11111111.
01000000.00000000) returns an E13 (Invalid value) error message.
VNM 250 • SIS Commands
128