Extron Electronics VN-Matrix 250 User Guide - Manual (Page 105)

Reset Sub-menu
The Reset sub‑menu allows you to reset many parameters to the factory defaults. It also
allows you to run the Sanitize process.
Reset
MENU NEXT
Reset [Factory IP]
[Activate]
NEXT
NEXT
Are you sure?
[Yes]
System Reset
in progress
Figure 82. VNE 250 Encoder Reset Sub-menu
1. In the main Reset screen, press Next to open the Reset Options screen.
2. In the Reset Options screen, use the right rotary encoder to select which type of reset
you want. You can choose Factory IP or Sanitize:
Factory IP — restores the following parameters to the factory default:
z
IP address
z
Subnet mask
z
Gateway IP address
z
Controller IP address
z
Link speed set to auto
z
Static IP address
z
Controller port number
For factory default values see figure 11 on page 24.
Sanitize — runs the sanitize process to overwrite volatile scaler memory (for the
on‑screen display), volatile Wavelet memory, and all non‑volatile memory. All these
memory locations are overwritten three times:
z
Firstly with a random pattern of zeroes and ones.
z
Secondly with binary zeroes.
z
Thirdly with binary ones.
3. Use the left rotary encoder to toggle between Activate or Cancel.
4. Press Next.
5. If you selected Activate in step 3, one of the reset processes runs. The screen shows
System Reset in Progress.
6. When the reset is complete, press Next to return to Encode Config sub-menu (see
page 93).
VNM 250 • Front Panel Menu Configuration 99