Extron Electronics VN-Matrix 250 User Guide - Manual (Page 79)

Configuring the Decoder Display
1. In the Configuration panel, click on display0 (see figure 57, 1 ):
1 1
Figure 57. Device Configuration Panel
The Display tab opens with display options (see figure 58). More information about the
Display tab can be found on page 58.
1 1
2 2
3 3
5 5 4 4
Figure 58. Display Tab
2. Set the Output Format from the drop‑down list (see figure 58, 1 ):
z
Auto — sets the display to the same resolution and refresh rate as the source
stream.
z
Monitor — sets the decoder output mode to the preferred resolution and frame
rate of the output monitor. To operate correctly, this feature requires the monitor to
support EDID properly.
z
Fixed — sets the decoder output mode to the chosen resolution and frame rate as
selected from the drop‑down list.
NOTE: The scale option must be enabled whenever Monitor or Fixed output
formats are selected.
3. Enable or disable the Nodata Splash , SoG , Scale , Genlock , Clean Switch , and
HDCP Mode check boxes (see figure 58, 2 ). For more information about these
check boxes , see page 58.
NOTE: The SoG mode is not supported by the VND 250. Selecting this option has
no effect.
VNM 250 • Configuration with the VNM 250 GUI 73