Extron Electronics VN-Matrix 250 User Guide - Manual (Page 103)

1. In the main Input screen, press Next to open the Input Source screen.
2. In the Input Source screen, use either rotary encoder to select the video source:
z
auto (selects HDMI whenever a digital source is detected)
z
HDMI (digital)
z
VGA (analog)
If the signal resolution and refresh rate are supported by VNE 250 (see Supported
EDID Modes on page 122), the LCD screen shows Supported source: resolution
and refresh rate of the signal. If the source signal is not supported, the screen shows
Unsupported Sce. If there is no source, the screen shows No source.
3. Press Next to open the Loop through screen.
4. Use either rotary encoder to enable or disable the signal to the loop‑through monitor.
z
When Enabled is selected, the source image or a splash screen is displayed on the
loop‑through monitor.
z
When Disabled is selected, the loop‑through signal, including sync, is disabled.
NOTE: This setting applies to both VGA and HDMI loop‑through signals.
5. Press Next to open the Power save screen.
6. Use either rotary encoder to enable or disable the power save feature.
z
When power save is Enabled, the loop‑through signal is disabled when input
source syncs have been removed for 1 minute.
z
When power save is Disabled, the loop‑through signal is always active.
NOTE:
• Power save is only effective when Loop through is Enabled.
• This setting applies to both VGA and HDMI loop‑through signals.
EDID Sub-menu
The EDID sub‑menu allows you to select the EDID that is provided to the source device.
EDID
MENU NEXT
EDID Source
HDMI
NEXT
Select EDID Source: HDMI
VGA
EDID HDMI [Location]
[EDID name]
Select Location:
Different “EDID name” options
populate the list, depending on
the “Location” selected.
Transparent (Trans)
Stored (stored)
Fixed (fixed)
NEXT
Figure 80. VNE 250 Encoder EDID Sub-menu
1. In the main EDID screen, press Next to open the EDID Source screen.
2. In the EDID Source screen, select the source type (HDMI or VGA).
3. Press Next to open the Location screen.
VNM 250 • Front Panel Menu Configuration 97