beautypg.com

Control – Extron Electronics VN-Matrix 250 User Guide User Manual

Page 101

background image

NEXT

LAN1-Control [IP, SM]

[IP address]

NEXT

NEXT

LAN1-Control [IP, SM]

[IP address]

NEXT

Less than

3 seconds

More than

3 seconds

LAN2-Stream [IP, SM]

[IP address]

LAN2-Stream [IP, SM]

[IP address]

NEXT

Sys Cntrl [IP, Port]

[IP address]

Sys Cntrl IP

[Item]

NEXT

Less than

3 seconds

More than

3 seconds

More than

3 seconds

Less than

3 seconds

Read Only

Editable

Network

MENU

Figure 78.

VNE 250 Encoder Network Sub-menu (Top Level)

To edit properties for any of these screens:

1.

Navigate to the required screen.

2.

Press the

Next button for more than 3 seconds. The screen flashes rapidly and the

selected value is shown in angled brackets.

3.

Edit the network properties as desired.

Control

The

LAN1-Control editing screen allows you to adjust the IP address (IP) and the subnet

mask (

SM) of the control network. The editing screen opens to show the IP address for

VNE 250 control port, with the first octet of the address enclosed in angled brackets (by
default, this is <192>168.253.254).

1.

Use the right rotary encoder to adjust the value of the highlighted octet.

2.

Use the left rotary encoder to highlight the next octet.

3.

Use the right rotary encoder to adjust this value as required.

4.

Repeat steps 2 and 3 to adjust all four octets as required.

5.

Press

Next to show the subnet mask for the VNE 250 control port.

6.

Repeat steps 1 to 4 to set the value for the subnet mask.

7.

Press

Next. You will be prompted to save the changes. Use either rotary encoder to

toggle between

Yes (save the changes and exit) and No (exit to the

LAN1-Control

screen, without saving).

8.

If you select

Yes, you will be prompted to reboot the device. Use either rotary encoder

to toggle between

Yes (to reboot) and No (exit to the LAN1‑Control screen, without

rebooting).

9.

If you select

Yes, the VNE 250 reboots. If you select No, the VNE 250 does not reboot,

but the changes saved in step 7 are saved and are applied the next time the VNE 250 is
powered up.

VNM 250 • Front Panel Menu Configuration

95