Extron Electronics VN-Matrix 250 User Guide - Manual (Page 73)

Configuring Encoder Video
9. In the Configuration panel, click on VideoPort0 (see figure 47, 1 ):
1 1
Figure 47. Device Configuration Panel
The Configure tab opens with video options.
1
1 1
2 2
3 3
4 4
5 5
Figure 48. Configure Tab (Video Options)
10. Ensure the Input Channel is set to auto (see figure 48, 1 ).
11. Set the EDID (D) for the digital video input and the EDID (A) for the analog input, as
required (see figure 48, 2 ).
12. If a digital source with HDCP is connected, ensure that the HDCP Authorize box is
selected (see figure 48, 3 ).
13. Ensure the Current Mode shows the format of the connected source (see
figure 48, 4 ).
14. If RTP multicast source streaming is
required, select the Multicast Enable box
(see figure 48, 5 ). A dialog is displayed
asking for a multicast address (see the
figure to the right). This must be obtained
from your network administrator.
If
RTP unicast is required, ensure the Multicast Enable box is deselected.
VNM 250 • Configuration with the VNM 250 GUI 67