Extron Electronics MS9500 HD FrEND Plus - Manual (Page 80)

MS9500GL HD FrEND Plus Chapter 12: Remote Control Protocols
GetState Retrieve status information from the player. (Playing, Paused,
Transitioning…)
GetVersion Retrieve version of HDPlayer application
GetDiskInfo Retrieve total disk space and free disk space in the D: partition of
the player
Timecode Commands
Tcgeneratehh:mm:ss:ff Turns the Timecode Generator on and sends timecode
hh:mm:ss:ff as a jam sync
Tcreceive Sets the player into timecode receive mode
Tcreceiveloop Sets the player into timcode receive mode and loops input
timecode to output
Sets the player to start playing at time hh:mm:ss:ff Tcplayathh:mm:ss:ff
Tcstart Starts the timecode running (assumes the player is in TC generate
mode)
GPIO Commands
Getinput Verify state of the GPIO Digital Inputs 1-4
GetOutput Verify state of the GPIO Changover Relay Outputs 1-4
SetOutput Set GPIO Changeover Relay Outputs 1-4 ‘On’ (+) or ‘Off’ (-)
76 Rev. 1.26