Extron Electronics MS9500 HD FrEND Plus - Manual (Page 51)

MS9500GL HD FrEND Plus Chapter 8: Transport & Status Display
Chapter 8: Transport Status Display
The HD Player interface is similar to that of a simple tape player: The tape is played until it reaches the end, when
a rewind is required to play again. In the case of the MS9500GL this rewind (Cue) is near instant, but the
metaphor provides a useful description.
The Status display is linked to the Transport Controls and shows various pieces of useful information about the
current state of the MS9500GL:
Mode
Indicators
Transport
Status Frame
Counter
Current
Timecode
Current
Chapter
and File
Analog
Audio
Volume
Cue To
Slider Transport + Output
Mode Buttons
Transport status
The transport status shows the current operating state of the MS9500GL. The display will show one of the
following messages.
Stopped
The Stopped indicator appears at Start-up of the HD Player software, only. The status will change when the first
file is cued.
Paused
The Paused indicator is displayed under the following circumstances.
• Paused will be shown after a file has been cued.
• Paused will be displayed if a file has been played and then stopped using either the transport controls or a
remote control message.
Cueing
The Cueing indicator will be shown when
• The cue button has been selected from the transport controls
• The user double-clicks a clip in the Playlist – selecting the Play button will run the cued clip
47 Rev. 1.26