Extron Electronics MS9500 HD FrEND Plus - Manual (Page 78)

MS9500GL HD FrEND Plus Chapter 12: Remote Control Protocols
Available Player Commands
The following table illustrates the commands that are supported by the HD Player.
Command Action
C6 Play
C5 Pause
E4 Video Off
E3 Video On
E5 Chapter Mode (FrameNo = first file to play in playlist)
E6 Frame Mode
83 Audio On
84 Audio Off
A2 Set stop point for play list. ( FrameNo = last file to play in playlist.)
To use the ES4000 protocol to control the HD Player, the following steps should be performed.
ƒ Set up a Playlist containing the files to be used in the installation.
ƒ Send a chapter start with the FrameNo field set to the first chapter to play in the Playlist.
ƒ Send a stop point with the FrameNo Field set to the last chapter to play in the Playlist.
ƒ Send a Play command to play the files.
Available Player Command Reference
Command Action
Configuration Commands
GetPlayerType Requests the type of player
GetChannelCount Requests number of Channels present on player
SetOutputMode Set the video output mode for the player
GetOutputMode Verify current video output mode of the player
GetOutputResolution Verify current video output resolution and frequency of the player
SetOutputResolution
Set the output resolution and frequency of the player
Media Management Commands
GetClips Lists clips available in a MediaBranch passed in the
parameter.
Startscheduler Enable Scheduler (9500)
Stopscheduler Disable Scheduler(9500)
74 Rev. 1.26