Extron Electronics MS9500 HD FrEND Plus - Manual (Page 74)

MS9500GL HD FrEND Plus Chapter 12: Remote Control Protocols
Videobars
Turn on video color bar output for the requested channel.
The Player will respond with
OK or ERROR
Loopon
Enable the Auto repeat mode. This will cause the channel to loop (auto-repeat) at the end of the selected files in
the playlist.
The Player will respond with:
OK or ERROR
Loopoff
Turn off the loop flag for the requested channel.
The Player will respond with:
OK or ERROR
Timecode Commands
NOTE: This section applies to the MS9500GL only - the MS9500 does not accommodate Timecode.
Tcgenerate
Turns the timecode generator on and sends the timecode hh:mm:ss:ff out as a jam sync.
The Player will respond with:
OK or ERROR
Tcreceive
Sets the player into timecode receive mode.
The Player will respond with:
OK or ERROR
Tcreceiveloop
Sets the player into timecode receive mode and loop the input timecode to the output.
The Player will respond with:
OK or ERROR
Tcplayat
Sets the timecode playat time
The Player will respond with:
OK or ERROR
70 Rev. 1.26