Extron Electronics MS9500 HD FrEND Plus - Manual (Page 26)

MS9500GL HD FrEND Plus Chapter 2: Player Configuration - LCD
7. Use the encoder to set the Stop Time then select OK and press ; an ‘Adding Playlist’ message
appears.
When the preset time is reached the scheduler will start the playlist and run it until the stop time is reached.
To Remove a Schedule:
1. Scroll to Schedules, press
2. Scroll to the day schedule and press TWICE
3. Scroll to Remove Playlist or Remove All and Press ; a ‘Removing Playlist’ message appears
Content: Test
Select specific files for test purposes – factory use only.
Communications
Use this menu for access to all of the remote control settings for the player.
Ethernet
This menu allows the MS9500GL to be set-up for use in a LAN.
Press the ‘Ethernet’ icon to access TCP/IP control options:
• Set IP Address – Select this feature and press. Adjust the IP as required; select OK
• Set Subnet Mask – Select this feature and press. Adjust the Subnet Mask as required; select OK
• Set Gateway – Select this feature and press. Adjust the Gateway as required; select OK
• Enable DHCP – Select this feature to toggle DHCP on or off.
NOTE: This would be a good time to record the MS9500GL’s IP address and name (Refer to section ‘System:
Computer Name’ later in this Chapter) as this information will be required for transferring MPEG files to the
MS9500GL with an FTP application (refer to following chapter).
RS232
This menu allows setup of the MS9500GL Comm Port for remote control with ESCAN or other control
application. Use the encoder to navigate to each window and highlight the necessary option. Press the to
select an option.
• MODE – Select from: Passthrough, Device or Control
Pass Through - Use the “Pass Through” setting to control another device such as a video projector
(RS232) from the MS9500GL with ESCAN or some other control system.
NOTE: When using the Pass Through setting ensure that the Baud Rate, Parity, Data Bits and Stop Bit are
set to match the device being controlled. Also, in your remote control program, set the IP Port Number to
4001 and the IP address to that of the HD FrEND Plus in use. In Pass Through mode any TCP/IP control
string appearing on port 4001of the HD FrEND Plus is passed to the RS232 port.
• Baud Rate – Select from the options presented: 9600, 19200, 38400, 57600, 115200
• Parity – Select from: None, Even or Odd
22 Rev. 1.26