QTECH QSW-8300 Инструкция по настройке - Manual (Page 364)

+7(495) 797-3311 www.qtech.ru
Москва, Новозаводская ул., 18, стр. 1
363
Chapter 45 Debugging and Diagnosis for
Packets Received and Sent by CPU
45.1 Introduction to Debugging and Diagnosis for Packets
Received and Sent by CPU
The following commands are used to debug and diagnose the packets received and sent by
CPU, and are supposed to be used with the help of the technical support.
45.2 Debugging and Diagnosis for Packets Received and Sent by
CPU Task List
Command Explanation
Global Mode
cpu-rx-ratelimit total
no cpu-rx-ratelimit total
Set the total rate of the CPU
receiving packets, the no command
sets the total rate of the CPU
receiving packets to default.
cpu-rx-ratelimit protocol
no cpu-rx-ratelimit protocol [ ]
Set the max rate of the CPU
receiving packets of the protocol
type, the no command set the max
rate to default.
clear cpu-rx-stat protocol [ ]
Clear the statistics of the CPU
received packets of the protocol type.
Admin Mode
show cpu-rx protocol [ ]
Show the information of the CPU
received packets of the protocol type.
debug driver {receive|send} [interface {
name> |all}] [protocol { |discard
|all}][detail]
Turn on the showing of the CPU
receiving or sending packet
informations.
no debug driver {receive |send}
Turn off the showing of the CPU
receiving or sending packet
informations.