QTECH QSW-8300 Инструкция по настройке - Manual (Page 208)

+7(495) 797-3311 www.qtech.ru
Москва, Новозаводская ул., 18, стр. 1
207
ip pim dense-mode
To enable PIM-DM protocol for the specified
interface.(Required)
2. Configure static multicast routing entries
Command Explanation
Global Configuration Mode
ip mroute
<.ifname>
no ip mroute <A.B.C.D>
<A.B.C.D> [<ifname> <.ifname>]
To configure a static multicast routing entry. The no form
of this command will remove the specified entry.
3. Configure additional PIM-DM parameters
Configure the interval for PIM-DM hello messages
Command Explanation
Interface Configuration Mode
ip pim hello-interval < interval>
no ip pim hello-interval
To configure the interval for PIM-DM hello messages.
The no form of this command will restore the interval to
the default value.
Configure the interval for state-refresh messages
Command Explanation
Interface Configuration Mode
ip pim state-refresh origination-
interval
no ip pim state-refresh
origination-interval
To configure the interval for sending PIM-DM state-
refresh packets. The no form of this command will
restore the default value.
Configure the boundary interfaces
Command Explanation
Interface Configuration Mode
ip pim bsr-border
no ip pim bsr-border
To configure the interface as the boundary of PIM-DM
protocol. On the boundary interface, BSR messages will
not be sent or received. The network connected the
interface is considered as directly connected network.
The no form of this command will remove the
configuration.
Configure the management boundary
Command Explanation
Interface Configuration Mode