QTECH QSW-8300 Инструкция по настройке - Manual (Page 213)

+7(495) 797-3311 www.qtech.ru
Москва, Новозаводская ул., 18, стр. 1
212
(Required).
2. Configure static multicast routing entries
Command Explanation
Global Configuration Mode
ip mroute
<.ifname>
no ip mroute <A.B.C.D> <A.B.C.D>
[<ifname> <.ifname>]
To configure a static multicast routing entry. The no
form of this command will remove the specified
static multicast routing entry.
3. Configure additional parameters for PIM-SM
Configure parameters for PIM-SM interfaces
Configure the interval for PIM-SM hello messages
Command Explanation
Interface Configuration Mode
ip pim hello-interval <interval>
no ip pim hello-interval
To configure the interval for PIM-SM hello
messages. The no form of this command restores
the interval to the default value.
Configure the hold time for PIM-SM hello messages
Command Explanation
Interface Configuration Mode
ip pim hello-holdtime <value>
no ip pim hello-holdtime
To configure the value of the holdtime field in the
PIM-SM hello messages. The no form of this
command will restore the hold time to the default
value.
Configure ACL for PIM-SM neighbors
Command Explanation
Interface Configuration Mode
ip pim neighbor-filter{<access-list-
number> }
no ip pim neighbor-filter{<access-list-
number> }
To configure ACL to filter PIM-SM neighbors. If
session to the neighbor has been denied by ACL,
then the sessions that have been set up will be
discarded immediately and new sessions will not
be set up.