QTECH QSW-8300 Инструкция по настройке - Manual (Page 269)

+7(495) 797-3311 www.qtech.ru
Москва, Новозаводская ул., 18, стр. 1
268
the interval to the default value.
2) Configure the hold time for PIM-SM6 hello messages
Command Explanation
Interface Configuration Mode
ipv6 pim hello-holdtime <value>
no ipv6 pim hello-holdtime
To configure the value of the holdtime field in the
PIM-SM hello messages. The no form of this
command will restore the hold time to the default
value.
3) Configure ACL for PIM-SM6 neighbors
Command Explanation
Interface Configuration Mode
ipv6 pim neighbor-filter cess-list-
name>
no ipv6 pim neighbor-filter cess-
list-name>
To configure ACL to filter PIM-SM6 neighbor. If
session to the neighbor has been denied by ACL,
then the sessions that have been set up will be
discarded immediately and new sessions will not
be set up.
4) Configure the interface as the boundary interface of the PIM-SM6 protocol
Command Explanation
Interface Configuration Mode
ipv6 pim bsr-border
no ipv6 pim bsr-border
To configure the interface as the boundary of PIM-
SM6 protocol. On the boundary interface, BSR
messages will not be sent or received. The network
connected the interface is considered as directly
connected network. The no form of this command
will remove the configuration.
5) Configure the interface as the management boundary of the PIM-SM6 protocol
Command Explanation
Interface Configuration Mode
ipv6 pim scope-border <500-
599>|<acl_name>
no ipv6 pim scope-border
To configure PIM-SM6 management boundary for
the interface and apply ACL for the management
boundary. With default settings, ffx0::/13 is
considered as the scope of the management group.
If ACL is configured, then the scope specified by
ACL permit command is the scope of the
management group. acl_name should be standard
IPv6 ACL name. The no form of this command will
remove the configuration.