QTECH QSW-8300 Инструкция по настройке - Manual (Page 274)

+7(495) 797-3311 www.qtech.ru
Москва, Новозаводская ул., 18, стр. 1
273
1. Enable ANYCAST RP v6 function
Command Explanation
Global Configuration Mode
ipv6 pim anycast-rp
no ipv6 pim anycast-rp
Enable ANYCAST RP function. (necessary)
The no operation will globally disable the ANYCAST RP
function.
2. Configure ANYCAST RP v6
(1) Configure RP candidate
Command Explanation
Global Configuration Mode
ipv6 pim rp-candidate
{vlan<vlan-id>
|loopback<index> |<ifname>}
[<A:B::C:D>][<priority>]
no ipv6 pim rp-candidate
Now, the PIM-SM has allowed the Loopback interface to
be a RP candidate.(necessary)
Please pay attention to that, ANYCAST RP protocol can
configure the Loopback interface or a regular three-layer
VLAN interface to be the RP candidate. In make sure that
PIM routers in the network can find where the RP locates,
the RP candidate interface should be added into the
router.
No operation will cancel the RP candidate configured on
this router.
(2) Configure self-rp-address (the RP communication address of this router)
Command Explanation
Global Configuration Mode
ipv6 pim anycast-rp self-rp-
address A:B::C:D
no ipv6 pim anycast-rp self-rp-
address
Configure the self-rp-address of this router (as a RP).
This address can be used to exclusively identify this
router when communicating with other RP.(necessary)
the effect of self-rp-address refers to two respects:
1 Once this router (as a RP) receives the register
message from a DR unicast, it needs to forward the
register message to all the other RP in the network,
notifying them of the state of source (S.G). While
forwarding the register message, this router will change
the source address of it into self-rp-address.
2 Once this router(as a RP) receives a register message
from other RP unicast, such as a register message
whose destination is the self-rp-address of this router, it