QTECH QSW-8300 Инструкция по настройке - Manual (Page 103)

+7(495) 797-3311 www.qtech.ru
Москва, Новозаводская ул., 18, стр. 1
102
to | dscp-intp
dscp list> to | dscp-dp to
)
no mls qos map (cos-dp | dscp-dscp | dscp-
intp | dscp-dp)
mls qos map intp-dscp
no mls qos map intp-dscp
command restores the default mapping
value.
6. Clear accounting data of the specific ports or VLANs
Command Explanation
Admin Mode
clear mls qos statistics [interface
name> | vlan ]
Clear accounting data of the specified
ports or VLAN Policy Map. If there are
no parameters, clear accounting data of
all policy map.
7. Show configuration of QoS
Command Explanation
Admin Mode
show mls qos maps [cos-dp | dscp-dscp |
dscp-intp | dscp-dp | intp-dscp]
Display the configuration of QoS mapping.
show class-map []
Display the classified map information of
QoS.
show policy-map [] Display the policy map information of QoS.
show mls qos {interface []
[policy | queuing] | vlan }
Displays QoS configuration information on a
port.
12.3 QoS Example
Example 1:
Enable QoS function, change the queue out weight of port ethernet 1/0/1 to 1:1:2:2:4:4:8:8, set
the port in trust CoS mode without changing DSCP value, and set the default CoS value of the
port to 5.
The configuration steps are listed below:
Switch#config
Switch(config)# mls qos queue weight 1 1 2 2 4 4 8 8
Switch(Config-If-Ethernet 1/0/1)#mls qos trust cos