QTECH QSW-8300 Инструкция по настройке - Manual (Page 132)

+7(495) 797-3311 www.qtech.ru
Москва, Новозаводская ул., 18, стр. 1
131
(15) Set the flag representing whether the address information will be obtained via DHCPv6
Command Explanation
Interface Configuration Mode
ipv6 nd managed-config-flag
Set the flag representing whether the address
information will be obtained via DHCPv6.
3. IPv6 Tunnel Configuration
(1) Add/Delete tunnel
Command Explanation
Global mode
interface tunnel
no interface tunnel
Create a tunnel. The NO command deletes a
tunnel.
(2) Configure tunnel description
Command Explanation
Tunnel Configuration Mode
description
no description
Configure tunnel description. The NO command
deletes the tunnel description.
(3) Configure tunnel source
Command Explanation
Tunnel Configuration Mode
tunnel source { |
| }
no tunnel source
Configure tunnel source end IPv4/IPv6 address.
The NO command deletes the IPv4/IPv6 address of
tunnel source end.
(4) Configure Tunnel Destination
Command Explanation
Tunnel Configuration Mode
tunnel destination { |
}
no tunnel destination
Configure tunnel destination end IPv4/IPv6
address. The NO command deletes the IPv4/IPv6
address of tunnel destination end.
(5) Configure Tunnel Next-Hop
Command Explanation
Tunnel Configuration Mode