QTECH QSW-8300 Инструкция по настройке - Manual (Page 15)

+7(495) 797-3311 www.qtech.ru
Москва, Новозаводская ул., 18, стр. 1
14
2. Configure the properties for the Ethernet ports
Command Explanation
Port Mode
combo-forced-mode {copper-forced |
sfp-forced}
Sets the combo port mode (combo ports only).
shutdown
no shutdown
Enables/Disables specified ports.
name
no name
Names or cancels the name of specified ports.
mdi { auto | across | normal }
no mdi
Sets the cable type for the specified port; this
command is not supported by combo port and
fiber port of switch.
speed-duplex {auto [10 [100 [1000]] [auto
| full | half |]] | force10-half | force10-full |
force100-half | force100-full | force100-fx
[module-type {auto-detected | no-phy-
integrated | phy-integrated}] | {{force1g-
half | force1g-full} [nonegotiate [master |
slave]]}| force10g-full}
no speed-duplex
Sets port speed and duplex mode of
100/1000Base-TX or 100Base-FX ports. The no
format of this command restores the default
setting, i.e., negotiates speed and duplex mode
automatically.
negotiation {on|off}
Enables/Disables the auto-negotiation function
of 1000Base-FX ports.
bandwidth control [both |
receive | transmit]
no bandwidth control
Sets or cancels the bandwidth used for
incoming/outgoing traffic for specified ports.
flow control
no flow control
Enables/Disables traffic control function for
specified ports.
loopback
no loopback
Enables/Disables loopback test function for
specified ports.
rate-suppression {dlf | broadcast |
multicast} <packets>
Enables the storm control function for
broadcasts, multicasts and unicasts with
unknown destinations (short for broadcast), and
sets the allowed broadcast packet number; the
no format of this command disables the
broadcast storm control function.
port-scan-mode {interrupt | poll}
no port-scan-mode
Configure port-scan-mode as interrupt or poll
mode, the no command restores the default
port-scan-mode.
rate-violation <200-2000000> [recovery Set the max packet reception rate of a port. If