QTECH QSW-8300 Инструкция по настройке - Manual (Page 264)

+7(495) 797-3311 www.qtech.ru
Москва, Новозаводская ул., 18, стр. 1
263
3) Configure the boundary interfaces
Command Explanation
Interface Configuration Mode
ipv6 pim bsr-border
no ipv6 pim bsr-border
To configure the interface as the boundary of PIM-
DM6 protocol. On the boundary interface, STATE
REFRESH messages will not be sent or received.
The network connected the interface is considered
as directly connected network. The no form of this
command will remove the configuration.
4) Configure the management boundary
Command Explanation
Interface Configuration Mode
ipv6 pim scope-border <500-
599>|<acl_name>
no ipv6 pim scope-border
To configure PIM-DM6 management boundary for
the interface and apply ACL for the management
boundary. With default settings, ffx0::/13 is
considered as the scope of the management group.
If ACL is configured, then the scope specified by
ACL permit command is the scope of the
management group. acl_name should be standard
IPv6 ACL name. The no form of this command will
remove the configuration.
4. Disable PIM-DM protocol
Command Notes
Interface Configuration Mode
no ipv6 pim dense-mode To disable PIM-DM for the specified interface.
Global Configuration Mode
no ipv6 pim multicast-routing To disable PIM-DM globally.
29.1.3 PIM-DM6 Typical Application
As shown in the following figure, add the Ethernet interfaces of Switch A and Switch B to
corresponding vlan, and start PIM-DM Protocol on each vlan interface.