QTECH QSW-8300 Инструкция по настройке - Manual (Page 263)

+7(495) 797-3311 www.qtech.ru
Москва, Новозаводская ул., 18, стр. 1
262
Command Explanation
Command configuration mode
ipv6 pim multicast-routing
To enable PIM-DM multicast routing global.
However, in order to enable PIM-DM for specific
interfaces, the following command must be issued.
Enable PIM-SM for the specific interface:
Command Explanation
Interface configuration mode
ipv6 pim dense-mode
To enable PIM-DM for the specified interface
(required).
2. Configure static multicast routing entries
Command Explanation
Global configuration mode
ipv6 mroute
<.ifname>
no ipv6 mroute <X:X::X:X>
<X:X::X:X> [<ifname> <.ifname>]
To configure IPv6 static multicast routing entries.
The no form of this command will remove the
specified routing entry.
3. Configure additional PIM-DM parameters
(1) Configure parameters for PIM-DM interfaces
1) Configure the interval for PIM-DM hello messages
Command Explanation
Interface Configuration Mode
ipv6 pim hello-interval <interval>
no ipv6 pim hello-interval
To configure the interval for PIM-DM hello
messages. The no form of this command will
restore the default value.
2) Configure the interval for PIM-DM state-refresh messages
Command Explanation
Interface Configuration Mode
ipv6 pim state-refresh origination-
interval
no ipv6 pim state-refresh origination-
interval
To configure the interval for sending PIM-DM state-
refresh packets. The no form of this command will
restore the default value.