QTECH QSW-8300 Инструкция по настройке - Manual (Page 265)

+7(495) 797-3311 www.qtech.ru
Москва, Новозаводская ул., 18, стр. 1
264
SWITCHA SWITCHB
vlan2
vlan1
vlan2
vlan1
PIM-DM Typical Environment
The configuration procedure for SwitchA and SwitchB is as below:
(1) Configure SwitchA:
Switch(config)#ipv6 pim multicast-routing
Switch(config)#interface vlan 1
Switch(Config-if-Vlan1)#ipv6 address 2000:10:1:1::1/64
Switch(Config-if-Vlan1)#ipv6 pim dense-mode
Switch(Config-if-Vlan1)#exit
Switch(config)#interface vlan2
Switch(Config-if-Vlan2)#ipv6 address 2000:12:1:1:: 1/64
Switch(Config-if-Vlan2)#ipv6 pim dense-mode
(2) Configure SwitchB:
Switch(config)#ip pim multicast-routing
Switch(config)#interface vlan 1
Switch(Config-if-Vlan1)#ipv6 address 2000:12:1:1::2/64
Switch(Config-if-Vlan1)#ipv6 pim dense-mode
Switch(Config-if-Vlan1)#exit
Switch(config)#interface vlan 2
Switch(Config-if-Vlan2)#ipv6 address 2000:20:1:1::1/64
Switch(Config-if-Vlan2)#ipv6 pim dense-mode
29.1.4 PIM-DM6 Troubleshooting
When configuring and using PIM-DM protocol, PIM-DM protocol may fail to work normally due
to physical connections, incorrect configuration and so on. So, users shall note the following
points:
Assure the physical connection is correct.
Assure the Protocol of Interface and Link is UP (use show interface command);
Assure PIM Protocol is turned on in Global Mode (use ipv6 pim multicast-routing command )
Start PIM-DM Protocol on the interface (use ipv6 pim dense-mode command)
Unicast route shall be used to carry out RPF examination for multicast protocol. So the