QTECH QSW-8300 Инструкция по настройке - Manual (Page 277)

+7(495) 797-3311 www.qtech.ru
Москва, Новозаводская ул., 18, стр. 1
276
Switch#config
Switch(config)#interface loopback 1
Switch(Config-if-Loopback1)#ipv6 address 2006::1/128
Switch(Config-if-Loopback1)#exit
Switch(config)#ipv6 pim rp-candidate loopback1
Switch(config)#ipv6 pim multicast-routing
Switch(config)#ipv6 pim anycast-rp
Switch(config)#ipv6 pim anycast-rp self-rp-address 2004::2
Switch(config)#ipv6 pim anycast-rp 2006::1 2003::1
Please pay attention to that, for promulgating loopback interface router, if use MBGP4+
protocol, then can use network command; or use RIPng protocol, then can use route
command.
29.3.4 ANYCAST RP v6 Troubleshooting
When configuring and using ANYCAST RP v6 function, the ANYCAST RP might work
abnormally because of faults in physical connections, configurations or something others. So,
the users should pay attention to the following points:
The physical connections should be guaranteed to be correct
The PIM-SM6 protocol should be guaranteed to operate normally
The ANYCAST RP should be guaranteed to be enabled in Global configuration mode
The self-rp-address should be guaranteed to be configured correctly in Global configuration
mode
The other-rp-address should be guaranteed to be configured correctly in Global configuration
mode
All the interface routers should be guaranteed to be correctly added, including the loopback
interface as a RP
Use “show ipv6 pim anycast rp status” command to check whether the configuration
information of ANYCAST RP is correct
If the problems of ANYCAST still cannot be solved after checking, please use debug
commands like “debug ipv6 pim anycast-rp”, then copy the DEBUG information within three
minutes and send it to the technical service center of our company.
29.4 PIM-SSM6
29.4.1 Introduction to PIM-SSM6
Source Specific Multicast (PIM-SSM6) is a new kind of multicast service protocol. With PIM-
SSM6, a multicast session is distinguished by the multicast group address and multicast
source address. In SSM6, hosts can be added into the multicast group manually and efficiently