QTECH QSW-8300 Инструкция по настройке - Manual (Page 231)

+7(495) 797-3311 www.qtech.ru
Москва, Новозаводская ул., 18, стр. 1
230
2 The configuration is allowed to be done with
the absence of the interface in accordance
with the anycast-rp-addr.
Configure on this router (as a RP) the other-
rp-addresses of other RP communicating with
it. This unicast address identifies other RP
and is used in the communication with local
routers.
The effect of other-rp-address refers to two
respects:
1 Once this router (as a RP) receives the
register message from a DR unicast, it should
forward it to other RP in the network to notify
all the RP in the network of the source (S.G)
state. While forwarding, the router will change
the destination address of the register
message into other-rp-address.
2 Multiple other-rp-addresses can be
configured in accordance with one anycast-rp-
addr, Once the register message from a DR is
received, it should be forwarded to all of these
other RP one by one.
No operation will cancel an other-rp-address
communicating with this router.