QTECH QSW-8300 Инструкция по настройке - Manual (Page 133)

+7(495) 797-3311 www.qtech.ru
Москва, Новозаводская ул., 18, стр. 1
132
tunnel nexthop
no tunnel nexthop
Configure tunnel next-hop IPv4 address. The NO
command deletes the IPv4 address of tunnel next-
hop end.
(6) Configure Tunnel Mode
Command Explanation
Tunnel Configuration Mode
tunnel mode [[gre] | ipv6ip [ 6to4 |
isatap]]
no tunnel mode
Configure tunnel mode. The NO command clears
tunnel mode.
(7) Configure Tunnel Routing
Command Explanation
Global mode
ipv6 route
length> {
number> | tunnel }
no ipv6 route
length> {
number> | tunnel }
Configure tunnel routing. The NO command clears
tunnel routing.
16.2.3 IP Configuration Examples
16.2.3.1 Configuration Examples of IPv4
IPv4 configuration example
The user’s configuration requirements are: Configure IP address of different network segments
on Switch1 and Switch2, configure static routing and validate accessibility using ping function.
Configuration Description:
Configure two VLANs on Switch1, namely, VLAN1 and VLAN2.
Switch
2
Switch
1
PC2
PC1