QTECH QSW-8300 Инструкция по настройке - Manual (Page 135)

+7(495) 797-3311 www.qtech.ru
Москва, Новозаводская ул., 18, стр. 1
134
The user’s configuration requirements are: Configure IPv6 address of different network
segments on Switch1 and Switch2, configure static routing and validate reachability using
ping6 function.
Configuration Description:
Configure two VLANs on Switch1, namely, VLAN1 and VLAN2.
Configure IPv6 address 2001::1/64 in VLAN1 of Switch1, and configure IPv6 address
2002::1/64 in VLAN2.
Configure 2 VLANs on Switch2, namely, VLAN2 and VLAN3.
Configure IPv6 address 2002::2/64 in VLAN2 of Switch2, and configure IPv6 address
2003::1/64 in VLAN3.
The IPv6 address of PC1 is 2001::11/64, and the IPv6 address of PC2 is 2003::33/64.
Configure static routing 2003:33/64 on Switch1, and configure static routing 2001::11/64 on
Switch2.
ping6 each other among PCs.
Note: First make sure PC1 and Switch1 can access each other by ping, and PC2 and Switch2
can access each other by ping.
The configuration procedure is as follows:
Switch1(Config)#interface vlan 1
Switch1(Config-if-Vlan1)#ipv6 address 2001::1/64
Switch1(Config)#interface vlan 2
Switch1(Config-if-Vlan2)#ipv6 address 2002::1/64
Switch1(Config-if-Vlan2)#exit
Switch1(Config)#ipv6 route 2003::33/64 2002::2
Switch2(Config)#interface vlan 2
Switch2(Config-if-Vlan2)#ipv6 address 2002::2/64
Switch2(Config)#interface vlan 3
Switch2(Config-if-Vlan3)#ipv6 address 2003::1/64
Switch2(Config-if-Vlan3)#exit
Switch2(Config)#ipv6 route 2001::33/64 2002::1
Switch1#ping6 2003::33
Configuration result:
Switch1#show run
interface Vlan1
ipv6 address 2001::1/64
!
interface Vlan2
ipv6 address 2002::2/64
!