QTECH QSW-8300 Инструкция по настройке - Manual (Page 191)

+7(495) 797-3311 www.qtech.ru
Москва, Новозаводская ул., 18, стр. 1
190
ipv6 dhcp class
no ipv6 dhcp class
This command defines a DHCPv6 class and
enters DHCPv6 class mode, the no form of
this command removes this DHCPv6 class.
Interface configuration mode
ipv6 dhcp server select relay-forw
no ipv6 dhcp server select relay-forw
This command enables the DHCPv6 server
to support selections when multiple option 37
or option 38 options exist and the option 37
and option 38 of relay-forw in the innermost
layer are selected. The no operation of it
restores the default configuration, i.e.
selecting option 37 and option 38 of the
original packets.
IPv6 DHCP Class configuration mode
{remote-id [*] [*] | subscriber-id
[*] [*]}
no {remote-id [*] [*] |
subscriber-id [*] [*]}
This command configures option 37 and
option 38 that match the class in ipv6 dhcp
class configuration mode.
DHCPv6 address pool configuration mode
class
no class
This command associates class to address
pool in DHCPv6 address pool configuration
mode and enters class configuration mode in
address pool. Use no command to remove
the link.
address range
no address range
This command is used to set address range
for a DHCPv6 class in DHCPv6 address pool
configuration mode, the no command is used
to remove the addreass range. The
prefix/plen form is not supported.