EVS XEDIO CleanEdit Version 3.1 - January 2011 User Manual - Manual (Page 169)

Issue 3.1.B Xedio Suite Version 3.1 – User’s Manual – CleanEdit
EVS Broadcast Equipment – January 2011
158
9.2.5 A
DDING
A
UDIO
T
RANSITION
E
FFECTS ON
E
LEMENTS OF THE
S
AME
T
RACK
I
NTRODUCTION
You want to add audio transition effects to:
• a selected element OR
• contiguous elements
on a given audio track.
In this case, you will use the (Left/Right) Audio Transition commands in the
contextual menu available on audio elements in the timeline.
For more information on the various types of transition effects, refer to the section
9.2.4 ‘Possible Audio Transition Effects’, on page 157.
The following audio transition effects are available: Cut, Fade OUT, Fade IN,
Cross Fade.
H
OW TO
A
PPLY
A
UDIO
T
RANSITION
E
FFECTS
O
N
E
LEMENTS
ON THE
S
AME
T
RACK
To apply audio transition effects to one element or contiguous audio elements of
the same track, proceed as follows:
1. If you want to define a transition effect on several contiguous transitions, set a
mark IN and mark OUT points to cover the clips on which the effects should be
applied.
Otherwise, the transition effect will be defined on the nearest transition to the
position of the mouse cursor.
2. Right-click the mouse on the track where you want to define the transition
effect either:
o
near the clip transition OR
o
between the define mark IN and mark OUT
The contextual menu is displayed: