How to restripe the timecode of the current clip, 12 h, Ow to – EVS MulticamLSM Version 10.04 - January 2011 Operating Manual User Manual

Page 72: Estripe the, Imecode of the, Urrent

Issue

10.04.A

EVS Multicam Version 10.04 – Operating Manual

EVS Broadcast Equipment SA – January 2011

9.3.12 H

OW TO

ESTRIPE THE

IMECODE OF THE

URRENT

LIP

To restripe the timecode of the current clip, proceed as follows:

Recall the clip by moving the cursor on the desired clip and pressing

ENTER, or by clicking on it with the stylus.

Press ALT-T on the keyboard to call the SET TC function.
The Set Timecode screen is displayed (without TC Type field with PAL –

refer to note below):

If you want to modify the LTC timecode and date, type in the new timecode

for the Short IN point and date of the clip in the Set TC field below the LTC

field.

If you want to modify the user-defined timecode and date, type in the new

timecode for the Short IN point and date of the clip in the Set TC field below

the USER field.

If you want to modify the primary TC for this clip, press the A or B key which

corresponds to the requested primary TC.

Press F2 to select CAM or CLIP mode

•

In CAM mode, only the timecode of the camera angle loaded on the

primary channel will be changed.

•

In CLIP mode, the timecode of all camera angles of the clip will be

changed.

Press ENTER to confirm or ESC to cancel.

The entire clip is updated according to the new timecode value so that the

timecode remains continuous inside the whole clip.

Note
In 59.94Hz modes (NTSC), you can also select between DROP FRAME

and NON DROP FRAME modes by pressing the space bar.