EVS MulticamLSM Version 10.04 - January 2011 Operating Manual - Manual (Page 27)

EVS Multicam Version 10.04 – Operating Manual
EVS Broadcast Equipment SA – January 2011
Issue
10.04.A
17
When a cue point exists for the current picture on the primary channel (the CUE
button lights red), pressing the BROWSE key allows the operator to browse
through all existing cue points by turning the jog dial.
When the current picture on the primary channel is neither a c lip nor a cue point,
or if the operator is in Playlist mode, pressing the BROWSE key allows him to
browse inside the clips of the current playlist by turning the jog dial.
4.1.12 INSERT
This function inserts a clip before or after (depending on the Setup menu) the
current position inside the playlist.
4.1.13 ENTER
This function appends clip(s) at the end of the current playlist. This is also used to
confirm saving of clips, and validate various options and messages.
4.1.14 MENU
This function allows the operator to gain access to the secondary menu.
SHIFT+MENU on the Remote gains access to the Main menu.
Also used as an ESCAPE key to cancel some options and messages.
4.1.15 CLEAR
This function clears the IN / OUT/ playlist / CLIPS / CUE points.
Note
• To clear one CUE point, recall the desired cue point and press CLEAR
+ MARK key.
• To clear all cues: when current picture is not a CUE point, press
CLEAR + MARK key. A message appears to confirm the command.
4.1.16 NETWORK
This function gives access to the clips and/or record trains of other machines on
the network. After the selection of the machine, the way of selecting clips and
camera angles is similar to clips selection on the local LSM system. Refer to the
Chapter 13 ‘Operating on XNet Network’, on page 150 for more details.
4.1.17 GOTO TC
The Goto TC option allows the user to jump to a given timecode in the loaded train
or clip.