EVS MulticamLSM Version 10.04 - January 2011 Operating Manual - Manual (Page 190)

Issue
10.04.A
EVS Multicam Version 10.04 – Operating Manual
EVS Broadcast Equipment SA – January 2011
180
When no cue point has been defined on a block, pressing LAST CUE stops the
recording and cues to the first recorded frame.
R
ECORD
‘ARM’ or ‘REC’ commands on hypermotion cameras.
When the user presses RECORD for the first time, all the A/V material on the
memory blocks of the camera are deleted.
When the user presses RECORD subsequently, this initiates the loop recording on
the current memory block. The current memory bock is the selected memory block,
or the first available one, if no block has been selected.
TAKE
‘Trig/Stop Rec’ command on hypermotion cameras.
With a single-block memory or when the last block is reached, this stops the
recording.
With a multiple-block memory, it stops the record on the current block and starts
automatically the record on the next block.
Note
With a multiple-block memory, and with Vision Research cameras only,
the block on which the record is stopped by a TAKE action is directly and
automatically played while a record is started on the next available
block.
LEVER
No corresponding command on hypermotion cameras.
Pressing the LEVER command shifts to the secondary lever range for material
played out using the hypermotion feature.
CAM K
EY
Pressing a CAM key corresponding to a recorded block loads the last recorded
frame on the selected block in play mode.
If you press a CAM key corresponding to an empty block, the Remote panel will
beep.
Note
With Vision Research cameras, pressing a CAM key corresponding to a
memory block in record stops the record on that block, and starts the
record on the next available block.