EVS MulticamLSM Version 10.04 - January 2011 Operating Manual - Manual (Page 189)

EVS Multicam Version 10.04 – Operating Manual
EVS Broadcast Equipment SA – January 2011
Issue
10.04.A
179
Setting Description Values
2 n d Lever Secondary lever range to be applied for
playing back material recorded on the
hypermotion camera.
0-1000, +- 1000
(default)
18.2.3 K
EY
C
OMMANDS
I
NTRODUCTION
This section presents the various commands you can use on the Remote Panel to
control the hypermotion camera. The corresponding command on the hyper motion
camera is mentioned when available.
The standard behavior, applicable to all cameras (Photron, Vision Research and
ARRI) is first explained. When a given camera has a specific behavior, this is
explicitly mentioned.
P
LAY
‘Play’ command on hypermotion cameras
Pressing the PLAY key on the LSM Remote panel initiates a replay from the first
frame available on the current memory block.
SHIFT+PLAY / -
No corresponding command on hypermotion cameras
Pressing the SHIFT+PLAY keys on the LSM Remote panel initiates a replay on the
current memory block at the speed defined in the PGMSpeed parameter.
Pressing again SHIFT+PLAY returns to the normal playing speed.
Mark
MARK
‘Mark Cue Point’ command on hypermotion cameras
With a single-block memory, pressing MARK marks a cue point of the current
block.
This is not available on all cameras with multiple-block memory.
L
AST
C
UE
Search command on hypermotion cameras.
With a single-block memory, pressing LAST CUE goes to the previous cue point if
cue points have been defined.
With a multiple-block memory, pressing LAST CUE goes to the previous cue point
of the current block if cue points have been defined on this block.