EVS MulticamLSM Version 10.04 - January 2011 Operating Manual - Manual (Page 195)

EVS Multicam Version 10.04 – Operating Manual
EVS Broadcast Equipment SA – January 2011
Issue
10.04.A
185
E
XAMPLE
The following steps provide an example for a typical use of the LSM Remote
commands with a Vision Research camera:
1. Initially, the blocks are recorded or empty
Block 1 Block 2 Block 3 Block 4
2. Press RECORD on the Remote to delete any recorded material on the blocks
and starts the recording in loop mode on block 1.
Block 1 Block 2 Block 3 Block 4
3. Press TAKE to stop recording on the current block, and start recording on
the next available one (block 2). Play starts on Block 1.
Block 1 Block 2 Block 3 Block 4
4. Press CLEAR to stop the play on B lock 1 and delete the material recorded
on that block. As the block 2 is being recorded, no record is started on block
1.
Block 1 Block 2 Block 3 Block 4
5. Press TAKE to stop the record on Block 2 and start it on the first available
block (Block 1). Play starts on block 2.
Block 1 Block 2 Block 3 Block 4
6. Press TAKE again to stop the record on block 1 and start it on the first
available block (Block 3). The play on block 2 is not affected.
Block 1 Block 2 Block 3 Block 4
7. Press CAM A to cue block 2 at the beginning, and load the last recorded
frame on block 1 in play mode. The record carries on block 3.
Block 1 Block 2 Block 3 Block 4
8. Press CAM C to stop the record on block 3 and start the record on the first
available block (block 4). The last recorded frame on block 3 is loaded in
play mode.
Block 1 Block 2 Block 3 Block 4
9. Press TAKE to stop the record on block 4.
Block 1 Block 2 Block 3 Block 4
10. Press CLEAR to stop the play on block 3, delete the material on block 3 and
start recording on block 3.
Block 1 Block 2 Block 3 Block 4