EVS MulticamLSM Version 10.04 - January 2011 Operating Manual - Manual (Page 59)

EVS Multicam Version 10.04 – Operating Manual
EVS Broadcast Equipment SA – January 2011
Issue
10.04.A
49
S
ORT
->TC
The Sort->TC function allows the operator to search the database for all c lips or
trains containing a specific timecode. Press SHIFT+C again in Set TC mode to call
it.
When calling this function, the timecode of the current picture is used as a default
selection. The operator can immediately perform the search or he can edit that
timecode before starting the search.
For more information on how to search for clips by timecode, refer to the section
9.2.9 ‘How to Search for Clips by Timecode’, on page 50.
S
ET
TC
The Set TC function is only available in SHIFT+B on the Sort->TC menu. It allows
the operator to restripe the timecode of a clip. This function is explained in details
in the Section 9.3.12 ‘How to Restripe the Timecode of the Current Clip’, on page
62.
Depending on the mode selected with the D key (CLIP/CAM), the new timecode
value is assigned only to the camera angle of the clip loaded on the primary
channel (CAM mode), or to all camera angles of the clip (CLIP mode).
N
AME
The Name function is only available if a keyword file is selected in the Setup
menu. It is used to name a clip based on available keywords. Refer to the Chapter
10 ‘Keyword Management’, on page 72 for more details. When the Name function
is selected, pressing SHIFT+C again will call the Search function.
S
EARCH
The Search function is “hidden” behind the Name function. Press SHIFT+C again
in Name mode to call it. It allows the operator to search the database for clips
based on keywords and ranking. Please refer to Chapter 10 ‘Keyword
Management’, on page 72 for details.
P
OST
-R
OLL
This function
enables/disables the Post-Roll mode. This mode is explained in details in the
section ‘PostRoll’, on page 28.