EVS MulticamLSM Version 10.04 - January 2011 Operating Manual - Manual (Page 41)

EVS Multicam Version 10.04 – Operating Manual
EVS Broadcast Equipment SA – January 2011
Issue
10.04.A
31
2nd CTRL
This function allows the operator to swap the control of one or several play
channels between the EVS Remote Panel and a third-party controller. Both
controllers receive permanently the status of the channel(s), but only one
controller at a time is able to actually control a channel. The secondary controllers
are defined in Section 7 of the Remote Setup menu.
Press this function to enter the 2nd CTRL menu, select the channels that you want
to pass to the secondary controller by pressing the corresponding A or B key, then
press D (DONE) to validate your selection. Do the same to bring the control of a
channel back to the EVS remote.
6.2 FULL CONTROL AND LEVER CONTROL
Controlling both PGM and PRV is done when PRV CTL (direct access key from the
remote) is not activated.
Once selecting PRV CTL the operator will have control of the PRV with the jog dial
and most buttons, while the lever and the Play button will control the PGM output.
At this point, selecting clips will call them up on the PRV side.
The combination of the PRV CTRL and the SW to IN functions allows the operator
to auto-chain cameras from the same IN point.
When an IN point has been marked, the operator activates the PRV CTL and sets
ON the SW to IN option. Then the slow motion of one camera can be started from
this IN point. The operator selects another camera in the PRV output and, via the
TAKE button, can auto-chain cameras from the same IN point on the PGM output.