3 recalling a clip, How to recall a clip, Clip recalled based on the pref setting – EVS MulticamLSM Version 10.04 - January 2011 Operating Manual User Manual

Page 51: Toggling between the camera angles, Recalling a clip, Pref, Ecalling a

EVS Multicam Version 10.04 – Operating Manual

EVS Broadcast Equipment SA – January 2011

Issue

10.04.A

9.2.3 R

ECALLING A

LIP

OW TO

ECALL A

LIP

To recall a clip, proceed as follows:

Select the Clip page 1, 2, 3, … to 10 (PAGE key).

Select the bank in which the desired clip is located

Select the desired clip via the F1 - F10 keys.

LIP

ECALLED

ASED ON THE

PREF

ETTING

If PREF is ON, the preferred camera angle of the clip will appear on the primary

channel, the secondary camera angle on the next controlled channel, then the

other camera angles on the next channels in alphabetical order.
Example: If the preferred camera angle for clip 124 is camera C, when loading the

clip, 124C is loaded on the primary channel, whatever the camera present on that

channel before loading the clip.
If PREF is OFF, when recalling the clip, the camera angle will be the same as the

one who was already present on each controlled channel. If that camera angle

does not exist, the first available camera angle of the clip will be used.
Example: If camera B is the current camera on the primary channel, when calling

clip 124, it is 124B that appears on the primary channel, even if it is not the

preferred camera angle.
When the operator is controlling only one channel (such as with PrvCtl), the clip

will appear at that location only. In the case of a clip containing a single camera

angle (only an «A», «B», «C» or «D» c lip), when in full control of all outputs, the

clip recalled will appear on the primary channel.

OGGLING

ETWEEN THE

AMERA

NGLES

If “Recall Clip Toggle” is enabled in the Setup Menu, pressing several times the

F_ key will always recall the first frame of the clip, but showing the next camera

angle every time the F_ key is pressed.