Garmin G1000 Quest Kodiak - Manual (Page 75)

190-00590-00 Rev. C Garmin G1000 Pilot’s Guide for the Quest Kodiak 100 3-7
ENGINE INDICATION SYSTEM
Fuel calculations are based on the fuel flow totalizer and the displayed fuel remaining (LB REM), adjusted by
the pilot using the following softkeys:
• DEC FUEL – Decreases totalizer-based fuel remaining in 10-lb increments
• INC FUEL – Increases totalizer-based fuel remaining in 10-lb increments
• RST FUEL – Resets totalizer-based fuel remaining to the aircraft’s fuel capacity and the displayed fuel used (LB
USED) to zero
1 Torque Gauge
(TRQ FT-LB)
Displays engine torque in foot-pounds (ft-lb)
2 Interstage Turbine
Temperature Gauge
(ITT °C)
Displays Interstage Turbine Temperature (ITT) in degrees Celsius (°C)
3 Propeller Speed Gauge
(NP RPM)
Displays propeller speed in revolutions per minute (rpm)
4 Generator Speed Gauge
(NG %)
Displays gas generator speed as a percentage
5 Oil Pressure
(PRES PSI)
Displays engine oil pressure in pounds per square inch (psi)
6 Oil Temperature
(TEMP °C)
Displays engine oil temperature in °C
7 Fuel Flow
(FFLOW PPH)
Displays current fuel flow in pounds per hour (pph)
8 Fuel Pressure
(PRES PSI)
Displays current fuel pressure in psi
9 Fuel Quantities
(QTY L/R LB)
Displays quantities of fuel in pounds (lb) in the left (L) and right (R) tanks
10 Set Fuel Remaining
(LB REM)
Displays current fuel remaining in lb as set by the pilot and adjusted for fuel
burn since last set
11 Calculated Fuel Used
(LB USED)
Displays quantity of fuel used in lb based on fuel flow since last reset
12 Calculated Endurance
(ENDUR)
Displays flight time remaining in hours:minutes (HH:MM) based on the
calculated fuel remaining
13 Calculated Range
(RANGE NM)
Displays aircraft range in nautical miles (nm) based on the calculated fuel
remaining, the aircraft’s heading, and the wind direction and speed
12 Aileron and Rudder Trim
Bars (AIL, RUD)
Aileron and rudder trim are indicated with pointers along slide bars; the white
bars indicate takeoff trim positions
13 Elevator Trim Bar
(ELEV)
Elevator trim is indicated with a pointer along a slide bar; takeoff trim position
is indicated with a white bar and T/O label
14 Flap Position Indicator
(FLAPS)
Flap deflection is indicated with a pointer along a color-coded slide bar