Garmin G1000 Quest Kodiak - Manual (Page 55)

190-00590-00 Rev. C Garmin G1000 Pilot’s Guide for the Quest Kodiak 100 2-11
FLIGHT INSTRUMENTS
BEARING POINTERS AND INFORMATION WINDOWS
NOTE: When the Arc HSI is displayed, the Bearing Information windows and pointers are disabled.
Two bearing pointers and associated information (Figure 2-18) can be displayed on the HSI by pressing the
PFD Softkey then a BRG Softkey. Use the BRG Softkey to cycle through bearing sources (NAV, GPS). The
pointers are light blue and are single- (BRG1) or double-lined (BRG2); an icon is shown in the respective
information window to indicate the pointer type. The bearing pointers never override the CDI and are
visually separated from the CDI by a white ring (shown even when bearing pointers are selected but not
necessarily visible due to data unavailability).
When a bearing pointer is displayed, its associated information window is also displayed. The Bearing
Information Windows are displayed to the lower sides of the HSI and show:
• Bearing source (NAV, GPS)
• Pointer icon (single line, BRG1; double, BRG2)
• Frequency (NAV)
• Station/waypoint identifier (NAV, GPS)
• GPS-derived great circle distance to bearing source
Figure 2-18 HSI with Bearing Information
Bearing 2
Pointer
Bearing 1
Pointer
Bearing 2 Information Window
No
Waypoint
Selected
Pointer
Icon
Bearing
Source
Bearing 1 Information Window
Bearing
Source
Pointer
Icon
Distance to
Bearing Source
Station
Identifier
If the NAV radio is the selected bearing source and is tuned to an ILS frequency, the bearing pointer is
removed from the HSI and the frequency is replaced with “ILS”. Refer to the Audio Panel and CNS Section for
tuning information. If the NAV radio is not receiving the tuned VOR station, the bearing pointer is removed
from the HSI and the frequency displayed in the information window is replaced with “NO DATA”. When
NAV1 or NAV2 is the selected bearing source, the frequency is replaced by the station identifier when the
station is within range.
If GPS is the selected bearing source, the active waypoint identifier is displayed in lieu of a frequency. If an
active waypoint is not selected, the bearing pointer is removed from the HSI and “NO DATA” is displayed in
the information window.
Selecting bearing display and changing sources:
1) Press the PFD Softkey.
2) Press a BRG Softkey to display the desired bearing pointer and information window with a NAV source.
3) Press the BRG Softkey again to change the bearing source to GPS.
4) To remove the bearing pointer and information window, press the BRG Softkey again.