Garmin G1000 Quest Kodiak - Manual (Page 59)

190-00590-00 Rev. C Garmin G1000 Pilot’s Guide for the Quest Kodiak 100 2-15
FLIGHT INSTRUMENTS
Changing the ILS CDI Capture setting:
1) Use the FMS Knob to select the AUX - System Setup Page on the MFD.
2) Press the FMS Knob to activate the cursor.
3) Turn the large FMS Knob to highlight the ‘ILS CDI Capture’ field in the ‘GPS CDI’ Box (Figure 2-23).
4) Turn the small FMS Knob to highlight the desired setting and press the ENT Key.
Figure 2-23 System Setup Page,
ILS CDI Capture Setting
OBS MODE
Enabling Omni-bearing Selector (OBS) Mode (with the OBS Softkey) suspends the automatic sequencing
of waypoints in a GPS flight plan (GPS must be the selected navigation source), but retains the current
“active-to” waypoint as the navigation reference even after passing the waypoint. When OBS is disabled
(the OBS Softkey is selected again), GPS navigation returns to normal operation, with automatic sequencing
of waypoints. OBS Mode also allows a desired course to/from a waypoint to be set (with the CRS Knob);
pressing the CRS Knob re-centers the CDI and returns the course pointer to the waypoint bearing.
Figure 2-24 Omni-bearing Selector (OBS) Mode
Pressing the OBS Softkey
Suspends Waypoint Sequencing
GPS Selected
Extended
Course Line
OBS Mode
Enabled
Pressing the OBS Softkey Again
Returns to Normal Operation