Garmin G1000 Quest Kodiak - Manual (Page 311)

190-00590-00 Rev. C Garmin G1000 Pilot’s Guide for the Quest Kodiak 100 A-15
APPENDIX A
GDL 69 Message Advisories
Alerts Window Message Comments
GDL69 CONFIG – GDL 69 configura-
tion error. Config service req’d. GDL 69 configuration settings do not match those of backup configuration memory.
The G1000 system should be serviced.
GDL69 FAIL – GDL 69 has failed. A failure has been detected in the GDL 69. The receiver is unavailable. The G1000
system should be serviced
GDC 74A Message Advisories
Alerts Window Message Comments
GDC1 CONFIG – GDC1 configuration
error. Config service req’d. GDC 74A configuration settings do not match those of backup configuration
memory. The G1000 system should be serviced.
MANIFEST – GDC1 software
mismatch. Communication halted. The GDC 74A has incorrect software installed. The G1000 system should be
serviced.
BACKUP PATH – ADC1 using backup
data path. The GDC 74A is using a backup communications data path. The G1000 system
should be serviced when possible.
Miscellaneous Message Advisories
Alerts Window Message Comments
FPL WPT LOCK – Flight plan waypoint
is locked. Upon power-up, the G1000 system detects that a stored flight plan waypoint is
locked. This occurs when an aviation database update eliminates an obsolete
waypoint. The flight plan cannot find the specified waypoint and flags this message.
This can also occur with user waypoints in a flight plan that is deleted.
Remove the waypoint from the flight plan if it no longer exists in any database,
OR
update the waypoint name/identifier to reflect the new information.
FPL WPT MOVE – Flight plan
waypoint moved. The system has detected that a waypoint coordinate has changed due to a new
aviation database update. Verify that stored flight plans contain correct waypoint
locations.
TIMER EXPIRD – Timer has expired. The system notifies the pilot that the timer has expired.
DB CHANGE – Database changed.
Verify user modified procedures. This occurs when a stored flight plan contains procedures that have been manually
edited. This alert is issued only after an aviation database update. Verify that the
user-modified procedures in stored flight plans are correct and up to date.