Garmin G1000 Quest Kodiak - Manual (Page 25)

SYSTEM OVERVIEW
1-15 190-00590-00 Rev. C Garmin G1000 Pilot’s Guide for the Quest Kodiak 100
360 HSI – Press to display the 360° compass rose.
ARC HSI – Press to display the 140° viewable arc.
BRG2 (bearing) – Press to cycle through the following information:
NAV2 – Displays NAV2 waypoint frequency or identifier in the BRG2 information window.
GPS – Displays GPS waypoint identifier and GPS distance information in the BRG2 information window.
OFF – Removes the BRG2 information window.
STD BARO – Press to set the barometric pressure to 29.92 inches of mercury (1013 hPa by pressing the METRIC
softkey).
BACK – Press to return to the previous level softkeys.
ALERTS – Press to display the Alerts window.
OBS – Press to select OBS mode on the CDI when navigating by GPS (only available with active leg).
CDI – Press to change navigation mode on the CDI between GPS, VOR1, and VOR2.
XPDR – Press to display the transponder mode selection softkeys.
STBY – Press to select standby mode.
ON – Press to select mode A.
ALT – Press to select altitude reporting mode.
VFR – Press to automatically squawk 1200 (only in the U.S.A., refer to ICAO standards for VFR codes in other
countries).
CODE – Press to display transponder code selection softkeys 0-7.
0 through 7 – Press numbers to enter code.
IDENT – Press to provide special aircraft position identification to Air Traffic Control (ATC).
BKSP – Press to remove numbers entered one at a time.
BACK – Press to return to the previous level softkeys.
IDENT – Press to provide special aircraft position identification to Air Traffic Control (ATC).
BACK – Press to return to the previous level softkeys.
ALERTS – Press to display the Alerts window.