Garmin G1000 Quest Kodiak - Manual (Page 101)

190-00590-00 Rev. C Garmin G1000 Pilot’s Guide for the Quest Kodiak 100 4-25
AUDIO PANEL AND CNS
Figure 4-29 Transponder Softkeys (PFD)
Pressing the IDENT or BACK Softkey
returns to the top-level softkeys.
ALERTS
ALERTS BACK BKSP IDENT 7 6 5 4 3 2 1 0
STBY ON ALT VFR CODE IDENT BACK
XPDR IDENT
Pressing the IDENT Softkey returns to the top-level softkeys.
Pressing the BACK Softkey returns to the mode selection softkeys.
GND
TRANSPONDER MODE SELECTION
Mode selection can be automatic (Ground and Altitude Modes) or manual (Standby, ON, and Altitude Modes).
The STBY, ON , and ALT Softkeys can be accessed by pressing the XPDR Softkey.
Selecting a transponder mode:
1) Press the XPDR Softkey to display the Transponder Mode Selection Softkeys.
2) Press the desired softkey to activate the transponder mode.
GROUND MODE
Ground Mode is normally selected automatically when the aircraft is on the ground. The transponder
powers up in the last mode it was in when shut down. Ground Mode can be overridden by pressing any one
of the Mode Selection Softkeys. A green ‘GND’ indication and transponder code appear in the mode field of
the Transponder Data Box. In Ground Mode, the transponder does not allow Mode A and Mode C replies,
but it does permit acquisition squitter and replies to discretely addressed Mode S interrogations.
When Standby Mode has been selected on the ground, the transponder can be returned to Ground Mode
by pressing the GND Softkey.
GND
Mode
Figure 4-30 Ground Mode