Toshiba Adjustable Speed Drive H3 - Manual (Page 59)

TOSHIBA
8 - 24
LIQUID CRYSTAL DISPLAY ADJUSTMENT
RANGE
ITEM
NO.
PAGE
NO.
DISPLAY
RESOLUTION
FACTORY
SETTING
PARAMETER
DESCRIPTION
GROUP:COMMUNICATION SETTING PARAMETERS
Cycle power after changing any parameter in GROUP: COMMUNICATION SETTING PARAMETERS .
Table continued on next page
*Items 265 - 266 are available only when Item 264 Adjustment Range option 1 is selected.
**Item 267 is available only when Item 264 Adjustment Range option 2 or 3 is selected.
RS232 BAUD RATE 260 set RS232 baud rate 0: 2400 baud - 2 9-22
1: 4800 baud
2: 9600 baud
NUMBER OF DATA BITS 261 Number of data bits 0: 7 bits - 0 9-22
1: 8 bits
PARITY SETTING 262 Parity 0: Even parity - 0 9-22
1: Odd parity
INVERTER ID NUMBER 263 Inverter number 0 - 255 - 0 9-22
COMMUNICATION 264 Communication selection 0: Off - 0 9-23
SELECTION 1: RS485 board*
2: Tosline-F10,
DN board,
MB+ board,
RIO board**
3: Tosline-S20 **
4: 12-bit binary input
(option board)
5: BCD board
(0.1 Hz units)
6: BCD board
(1 Hz units)
MASTER/SLAVE 265* Master/follower selection 0: Follower - 0 9-23
SELECTION 1: Master (follower
follows master
freq. command)
2: Master (output
frequency)
RS485 BAUD RATE 266* RS485 baud rate 0: Normal mode - 0 9-23
1: High speed mode
TOSLINE-F10/S20 267** TOSLINE-F10/TOSLINE-S20 0: Off - 0 9-23
COMMAND INPUT command input 1: Frequency
command
2: Command input
3: Frequency
command,
command input
Specifications
Precautions
Wiring
Jumpers
Panel
Keypad
Parameters
Programming
Service
Dimensions
Index
Inspection