Toshiba Adjustable Speed Drive H3 - Manual (Page 41)

TOSHIBA
"LOW" CONTACTS 63 assign function to "LOW" 0 - 63 1 4 9-10
FUNCTION contact 5-1
"LOW" CONTACTS 64 "LOW" output contact 1 - 100 1 1 9-10
DELAY TIME delay time 5-1
"LOW" CONTACTS 65 "LOW" output contact 1 - 100 1 1 9-10
HOLD TIME hold time 5-1
"FL" CONTACTS 66 asssign function to "FL" output 0 - 63 1 10 9-10
FUNCTION contact 5-1
"FL" CONTACTS 67 "FL" output contacts 1 - 100 1 1 9-10
DELAY TIME delay time 5-1
"FL" CONTACTS 68 "FL" output contacts 1 - 100 1 1 9-10
HOLD TIME hold time 5-1
"OUT" CONTACTS 69 assign function to "OUT" 0 - 61 1 8 9-10
FUNCTION output contacts
(available on option board)
"OUT" CONTACTS 70 "OUT" output contact delay time 1 - 100 1 1 9-10
DELAY TIME (available on option board)
"OUT" CONTACTS 71 "OUT" output contact hold time 1 - 100 1 1 9-10
HOLD TIME (available on option board)
LOW SPEED SIGNAL 72 Low-speed signal frequency 0 - Max. Output Freq. 0.1/0.01 Hz 0.0 9-13
OUTPUT FREQ
ACC/DEC COMPLETE 73 Acc/Dec complete detection 0 - Max. Output Freq. 0.1/0.01 Hz 2.5 9-13
DETECT BAND bandwidth
SPEED REACH MAXIMUM 74 Speed reach high frequency 0 - Max. Output Freq. 0.1/0.01 Hz 0.0 9-13
FREQUENCY
SPEED REACH MINIMUM 75 Speed reach low frequency 0 - Max. Output Freq. 0.1/0.01 Hz 0.0 9-13
FREQUENCY
COMMERCIAL POWER/INV 76 Bypass control 0: Off - 0 9-13
SWITCHING OUTPUT 1: Automatic
switching upon trip
2: Switching upon
receipt of
switching
signal *
3: Both 1 and 2
above*
COMMERCIAL POWER/INV 77* Incoming power/inverter 0 - Max Output Freq 0.1/0.01 Hz 60.0 Hz 9-13
SWITCH FREQ switching frequency
8 - 6
GROUP:TERMINAL SELECTION PARAMETERS (cont'd)
PARAMETER
DESCRIPTION
LIQUID CRYSTAL DISPLAY ADJUSTMENT
RANGE
ITEM
NO.
PAGE
NO.
DISPLAY
RESOLUTION
FACTORY
SETTING
Table continued on next page
*Item 77 is available only when Item 76 Adjustment Range option 2 or 3 is selected.
Specifications
Precautions
Wiring
Jumpers
Panel
Keypad
Parameters
Programming
Service
Dimensions
Index
Inspection