Xcommand subzonead, Command reference - xcommand – TANDBERG D14049.04 User Manual

Page 251

251

D14049.04
JULY 2008

Grey Headline (continued)

SubZoneAdd

Adds and configures a new subzone.

SubZoneName

(r)

Assigns a name to this subzone.

Address:

Specifies an IP Address used (in conjunction with the IP Prefix Length) to identify a subnet to be assigned to this subzone.

PrefixLength: <0..128>

Specifies the number of bits of the Subnet IP Address which must match for an IP Address to belong in this subzone.

TotalMode:

Determines whether the Default Subzone has a limit on the total bandwidth being used by its endpoints at any one time. NoBandwidth: no bandwidth available. No calls can be made
to, from, or within the Default Subzone. Default: Unlimited.

Total: <1..100000000>

Sets the total bandwidth limit (in kbps) of the Default Subzone (applies only if Mode is set to Limited). Default: 500000.

PerCallInterMode:

Determines whether there is a limit on the bandwidth for any one call to or from an endpoint in this subzone. NoBandwidth: no bandwidth available. No calls can be made to or from
this subzone. Default: Unlimited.

PerCallInter: <1..100000000>

Specifies the bandwidth limit (in kbps) on any one call to or from an endpoint in this subzone (applies only if Mode is set to Limited). Default: 1920.

PerCallIntraMode:

Determines whether there is a limit on the bandwidth for any one call between two endpoints within this subzone. NoBandwidth: no bandwidth available. No calls can be made within
this subzone. Default: Unlimited.

PerCallIntra: <1..100000000>

Specifies the bandwidth limit (in kbps) for any one call between two endpoints within this subzone (applies only if Mode is set to Limited). Default: 1920.

Example:

xCommand SubZoneAdd SubZoneName: "BranchOffice" Address: "10.13.0.0" PrefixLength: 28 TotalMode: Limited Total: 1024 PerCallInterMode:

Limited PerCallInter: 512 PerCallIntraMode: Limited PerCallIntra: 512

SubZoneDelete

Deletes a subzone.

SubZoneId

(r)

: <1..100>

The index of the subzone to be deleted.

Example:

xCommand SubZoneDelete SubZoneId:2

TANDBERG