TANDBERG D14049.04 - Manual (Page 103)

103
D14049.04
JULY 2008
Grey Headline (continued)
Search Process
The process followed by the VCS when attempting to locate a destination endpoint
is shown in the diagram opposite.
The user enters into their endpoint the alias or address of the destination 1.
endpoint. This can be in a number of different formats .
The destination address is sent from the caller’s endpoint to its local VCS (i.e. 2.
the VCS to which it is registered).
The VCS applies any
3. pre-search transforms to the alias.
The VCS applies any 4. Administrator Policy to the (transformed) alias. If this
results in a new alias, the process starts again, with the new alias checked
against the pre-search transforms.
The VCS applies any
5. User Policy (if FindMe is enabled) to the alias. If the
alias is a FindMe name that resolves to one or more new aliases, the process
will start again; all the resulting aliases will be checked against pre-search
transforms and Administrator Policy.
The VCS then
6. searches, in order of priority, all its zones , including the Local
Zone (which includes any Peers). If the alias matches an ENUM zone, this may
return a URI. If so, the process starts again; the URI is checked against any
pre-search transforms, Administrator Policy and User Policy.
If the alias is found within the Local Zone or by one of the external zones, the
7.
VCS will attempt to place the call to that zone.
If the alias is not found, the VCS will respond with a message to say that the
8.
call has failed.
Call Processing Diagram
One of the functions of the VCS is to route calls to their appropriate destination,
based on the address or alias received from a locally registered endpoint or
external zone.
There are a number of steps involved in determining the destination of a call, and
some of these steps can involve transforming the alias or redirecting the call to
other aliases. It is important to understand the process before setting up your
dial plan so you can avoid circular references, where an alias is transformed from
its original format to a different format, and then back to the original alias.
The VCS is able to detect circular references. If it does identify one it will
terminate that branch of the search and return a “policy loop detected”
error message.
TANDBERG VIDEO COMMUNICATIONS SERVER
ADMINISTRATOR GUIDE
Introduction Getting Started
Overview and
Status
System
Configuration
VCS
Configuration
Zones and
Neighbors
Call
Processing
Bandwidth
Control
Firewall
Traversal
Appendices Applications Maintenance
Introduction