TANDBERG D14049.04 - Manual (Page 234)

234
D14049.04
JULY 2008
Grey Headline (continued)
Zones LocalZone Traversal H323 UDPProbe RetryCount: <1..65534>
Sets the number of times traversal-enabled endpoints registered directly with the VCS will attempt to send a UDP probe to the VCS.
Default: 5
Example: xConfiguration Zones LocalZone Traversal H323 UDPProbe RetryCount: 5
Zones LocalZone Traversal H323 UDPProbe RetryInterval: <1..65534>
Sets the frequency (in seconds) with which traversal-enabled endpoints registered directly with the VCS will send a UDP probe to the VCS.
Default: 2
Example: xConfiguration Zones LocalZone Traversal H323 UDPProbe RetryInterval: 2
Zones LocalZone TraversalSubZone Bandwidth PerCall Limit: <1..100000000>
Specifies the bandwidth limit (in kbps) applied to any one traversal call being handled by the VCS (applies only if Mode is set to Limited).
Default: 1920
Example: xConfiguration Zones LocalZone TraversalSubZone Bandwidth PerCall Limit: 1920
Zones LocalZone TraversalSubZone Bandwidth PerCall Mode:
Determines whether there is a limit on the bandwidth of any one traversal call being handled by the VCS.
NoBandwidth : no bandwidth available. No traversal calls can be made.
Default: Unlimited
Example: xConfiguration Zones LocalZone TraversalSubZone Bandwidth PerCall Mode: Limited
Zones LocalZone TraversalSubZone Bandwidth Total Limit: <1..100000000>
Specifies the total bandwidth (in kbps) allowed for all traversal calls being handled by the VCS (applies only if Mode is set to Limited).
Default: 500000
Example: xConfiguration Zones LocalZone TraversalSubZone Bandwidth Total Limit: 500000
Zones LocalZone TraversalSubZone Bandwidth Total Mode:
Determines whether or not there is a limit to the total bandwidth of all traversal calls being handled by the VCS.
NoBandwidth : no bandwidth available. No traversal calls can be made.
Default: Unlimited
Example: xConfiguration Zones LocalZone TraversalSubZone Bandwidth Total Mode: Limited
Zones Zone [1..200] DNS Interworking SIP Audio DefaultCodec : AALCD_56/AALCD_64/AMR>
Specifies which audio codec to use when empty INVITEs are not allowed.
Default: G711u
Example: xConfiguration Zones Zone [1..200] DNS Interworking SIP Audio DefaultCodec : G711u
TANDBERG VIDEO COMMUNICATIONS SERVER
ADMINISTRATOR GUIDE
Introduction Getting Started
Overview and
Status
System
Configuration
VCS
Configuration
Zones and
Neighbors
Call
Processing
Bandwidth
Control
Firewall
Traversal
Appendices Applications Maintenance
Command Reference - xConfiguration